This silicone thermal pad is adhesive in both sides
and keeps the printing surface fit with the heater PCB board of the 3D printer.
Thanks to a 1mm thickness, it is possible to install a thermistor
in direct contact with the building surface, simply making a linear cut in the silicone in order to accommodate the wiring.
Although the pad is adhesive, it is not sticky. This allows to remove the building surface for cleaning and put it again in its place without losing the adhesion. It's important to keep the silicone clean in the process.
With this silicone thermal pad it is not necessary anymore the use of heated bed clips in order to keep the building plate in its place. Attention! The thermal pad is extremely fragile. The protecting layer should be removed while placing the pad on the printing surface.