MK10 Aluminium Extruder Feeder

€12.20
5 1
,
5/ 5
Tax included
for direct extrusion, 1.75mm filament
Type
Quantity
Out-of-Stock

 

Tax included

 

Worldwide shipping

 

European warehouse

You may have written "MK10 extruder" in the search engine and suggested this page and now that you are here and you see the photo it is not what you are looking for because you wanted an extruder for your Creality CR-10 (or also CR10S and CR20) or for your Ender 3 (or also Ender 2 and Ender 5)? If so, what you are looking for is an extruder for cr-10 or ender 3 . If not, forget this paragraph and read on.

This new model of mk10 extrusion body has a better grip of the filament and that causes a higher precission and quality in the finishing of the pieces. The new mechanism makes the filament change much easier.

In addition to the aluminum body, the kit includes all the necessary bolts for mounting it to a NEMA17 motor (not included) and if you want to assemble a full direct extruder, you will also need the following;

1 x Special heater block MK10
1 x Aluminum heatsink
1 x Axial Fan 40x40mm
2 x Bolt Allen M3x40mm
1 x Barrel For 1.75mm Filament
1 x Nut M6
1 x Nozzle 0.4mm
1 x Extruder Core
1 x Heater Cartridge
1 x Thermistor With Cable

This extruder feeder is especially indicated for use in direct extruders (hence it is lower than the MK8 for example) but, if we leave aesthetic considerations aside, we can also use it in a bowden type configuration.

For a bowden extruder, we recommend to buy:
1 x PTFE Tube 2x4
1 x Entrance Tube Fitting
1 x Exit Tube Fitting
1 x Extruder v5 o v6
1 x Fan Duct 30x30mm v5
1 x Axial Fan 30x30x10mm

This product is only for 1.75mm filaments, due to the diameter of the inlet and outlet holes of the block
1323
Comments (0)
No customer reviews for the moment.