This synchronous GT2 timing belt, in combination with a GT2 pulley, obliterates the backslash, contributing to a better surface finishing when compared to the traditional T2.5 belt used in the original mendel.
This is the belt we today use in our printers, against the T2.5
The belt is served in an open, single and continuous piece with independence of the length bought. The user is responsible of cutting the belt in the required pieces, task that can be accomplished with scissors.
This is a reinforced rubber black belt, with a width of 6mm. It works beautifully in conjunction with out 7mm width GT2 pulley
No customer reviews for the moment.
Your review appreciation cannot be sent
Are you sure that you want to report this comment?
Your report has been submitted and will be considered by a moderator.
Your report cannot be sent
Write your review
Your comment has been submitted and will be available once approved by a moderator.