Traditionally, the heating bed is fastened with ordinary M3 screws and nuts which allow the surface to be adjusted and calibrated.
With these special M3 nuts it is much easier to level the heating bed thus the outer diameter of the nut is larger. This leads to more sensibility when calibrating manually and the result is an excellent adjustment of the printing surface.
671
1 Item
Comments (0)
No customer reviews for the moment.
Your review appreciation cannot be sent
Report comment
Are you sure that you want to report this comment?
Report sent
Your report has been submitted and will be considered by a moderator.
Your report cannot be sent
Write your review
Review sent
Your comment has been submitted and will be available once approved by a moderator.